grind on

英 [ɡraɪnd ɒn]

美 [ɡraɪnd ɑːn]

令人厌烦地继续下去

柯林斯词典

• PHRASAL VERB 令人厌烦地继续下去
  If you say that somethinggrinds on, you disapprove of the fact that it continues to happen in the same way for a long time.
  1. Civil war in the Sudan has been grinding on for nine years.
     苏丹内战已经持续了9年之久。

双语例句

• The influence of H_2O_2, NaCl and SA sand grind on germination characteristics of liquorice seeds
  H2O2、NaCl、SA处理对砂磨后甘草种子发芽特性的影响
• Legal actions grind only slowly on but watchdogs can get better at publicising their actions.
  法律行动只能缓慢地实施，但监管机构在宣传行动方面可以做得更好。
• A Manufacturing Quality Control System of Grind Based on Expert Fuzzy Control
  一种基于专家模糊控制磨削加工质量控制系统
• The Grind on Ceramics Surface With Water Medium
  陶瓷表面的水介质研磨
• Civil war in the Sudan has been grinding on for nine years.
  苏丹内战已经持续了9年之久。
• A Grind Manufacturing System Based on Fuzzy B-Spline Neural Network Control
  一种基于模糊B样条基函数神经网络控制的磨削加工系统
• Mortierella mycelium oil extractions by different pre-treatments ( moisture content, grind method, grind degree) under supercritical condition were studied The relation between grind degree, grind method and moisture content on oil extraction has been obtained
  研究了不同预处理（水分、粉碎粒度）的被孢霉菌丝体在二氧化碳超临界流体条件下的油脂萃取，确定了粉碎粒度、水分与油脂萃取之间的关系
• This paper studied the different element grind partitions effect on the wall deformation of the deep excavation. A nonlinear, three dimensional finite element technique for deep excavation analysis was proposed, which is used for prediction of ground surface settlement in the center section of an excavation.
  为此，研究了不同有限元网格划分下基坑变形的情况，提出一种非线性的、三维有限元分析手段，用于深基坑开挖过程中预测围护墙变形和地表沉降值。
• This essay mainly explains that the involutes of grind gear on the bottom of the tooth space is not deep enough is caused by meshing interference.
  阐述了磨齿齿轮在齿槽根部齿形渐开线不够深是啮合产生干涉的原因。
• Because the superalloy is difficult to grind and on the surface of grinding wheel there exists serious adhesive substance, the grinding force and temperature will increase remarkably, and the grinding ratio is very low.
  由于高温合金的难磨性以及磨削时砂轮表面存在严重的粘附物，因而使磨削力和磨削温度显著增高，磨削比非常低。